- #HOW TO RECORD YOUR SCREEN AND VOICE ON PC USING OBS STUDIO HOW TO#
- #HOW TO RECORD YOUR SCREEN AND VOICE ON PC USING OBS STUDIO FULL#
Now for the most important setting - the actual Gate level: the level below which the Gate will silence the periods between speech. If a Gate effect is properly configured, the listener should not be able to notice that it's there - the Gate should be removing only the noise in pauses between speech, or in other words, it should only be removing things that the listener shouldn't be able to hear in the first place. Next, I've increased the Release setting to around 200 msec - this is a personal preference, but I find that the Gate is more noticeable if it closes too fast. If you're a woman, you may not need to increase this setting.
I'm a man with a fairly low voice, so the first thing I do, is set the Highpass setting to around 80-90 Hz, to make sure the Gate doesn't overreact to my voice. To add a VST effect, press the plus-button and select VST Plugin, then select the actual effect, reagate-standalone, from the drop-down: To remove any background from pauses between speech, we use a Gate - in this case the ReaGate VST plug-in from the ReaPlugs package. Remember, we're going to add a Gate effect next, so don't try to fully remove the background noise - the Gate will remove any noise from pauses between speech, and the speech itself will naturally predominate much of the noise, so you're better off using a setting that lets a bit of noise through without muttering the speech.
You'll want to use as little noise suppression as necessary - don't overdo it, or the speech will be muttered.ĭefinitely do a test-recording and play it back on speakers while adjusting this effect! If you're listening on headphones, you will likely be much more sensitive to noise than on speakers - you will likely find that, on speakers, you don't need as much noise suppression as you think you might on headphones.
#HOW TO RECORD YOUR SCREEN AND VOICE ON PC USING OBS STUDIO FULL#
I needed around -20 dB of noise suppression to get a good clean signal, but as you may have noticed in the first screenshot, I'm using a Lavalier mic that needs a full 30 dB of Microphone Boost, so I have quite a bit of noise. This has only one setting for the Suppression Level, but getting this right is really important. To add each effect to the filter-chain, press the plus-button.įirst, add the Noise Suppression effect, which is built into OBS. I recommend using headphones to monitor the results while you're adding and adjusting each of the effects as we go along - once you think you have the right settings, do a quick recording, play it back on speakers, and adjust if needed. We're ready to start setting up the filter chain!
#HOW TO RECORD YOUR SCREEN AND VOICE ON PC USING OBS STUDIO HOW TO#
Note that, if you're on Windows 10, you may be using the standard Windows audio driver, which doesn't expose the Microphone Boost setting - watch this tutorial on how to fix that.Īdd the "Audio Input Source" or "Video Capture Source" as needed, click the gear-button in the list of audio sources and select Filters to open the dialog. If you can't get the signal to go high enough, increase the Microphone Boost setting - but note that (depending on your hardware) this may introduce noise, so avoid setting this higher than necessary. Going too high will cause the signal to distort. You'll want the input level to go almost to the top, but not quite - one or two bars under the maximum. Speak into the microphone loudly - the loudest you think you're going to speak while recording, and watch the input level. Position the windows so they are both visible - so you can see the little input level meter in the first dialog while adjusting the level in the second.
0 kommentar(er)
